Hainan Steel tells you: Steel layout method can be used which indicate what is required

Steel layout method can be used one-line show, showed double-track method and in-line and short-member show law and meet the following requirements:

1, when the single-wire show, the focus should use component cable (thin dashed line) position, a solid line indicates that selection member; asymmetric cross section should indicate cross-section display mode in the figure.

2, double-track show that the center of gravity should use component cable (thin dashed line) position, member using a thin solid line indicates the outer member summarize, thin dashed line indicates that the web or limb plate. Hainan Steel

3, when the singlet and short-member indicated that members should use the center of gravity line (thin dashed line) position, a solid line indicates that selection member; a short-member using a thin solid line indicates the outer member summarize, thin dashed line indicates that the web or limb plate; a short-member the actual length of the member length is generally 1/3 ~ 1/2.

4, to facilitate the show, asymmetric cross section can be used outside the summarized line positioning. Hainan Steel